Prosoft-technology AN-X-AMX Manuel d'utilisateur télécharger pdf (Page 13)

AN-X-DCSNet2 Page

1. Select the Ethernet adapter that’s connected to the AN-X. In most

cases there will be just one Ethernet adapter in the computer. The AN-X

must be on the same subnet as the computer.

2. Enter the MAC address of the AN-X you are configuring. This is

printed on the AN-X label. It consists of six pairs of hexadecimal digits,

separated by hyphens. In the example above, it’s 00-0c-1a-00-00-0a.

If the AN-X is already online, you can obtain its MAC address using the

Utilities/Locate All AN-X Modules command.

3. Enter the IP address you intend the AN-X to use.

Step 2

In step 2, you choose a method of restarting AN-X to put it in boot mode.

1 2 ... 8 9 10 11 12 13 14 15 16 17 18 ... 67 68

Pas de commentaire

Prosoft-technology AN-X-AMX Manuel d'utilisateur Page 13