ProSoft Technology inRA-x ILX34-AENWG Guide d'installation télécharger pdf (Page 37)

Procedures ILX34-AENWG ♦ POINT I/O Platform

Setup Guide Wireless Point I/O Adapter

ProSoft Technology, Inc. Page 37 of 79

July 31, 2009

5 Click OK

save the configuration.

The following illustration shows the I/O Configuration for this project.

Download the Sample Program to the Processor

Note: The key switch on the front of the ControlLogix processor must be in the REM or PROG

position.

1 If you are not already online with the processor, open the COMMUNICATIONS

menu, and then choose DOWNLOAD. RSLogix will establish communication

with the processor.

2 When communication is established, RSLogix will open a confirmation dialog

box. Click the D

OWNLOAD button to transfer the sample program to the

processor.

3 RSLogix will compile the program and transfer it to the processor. This

process may take a few minutes.

4 When the download is complete, RSLogix will open another confirmation

dialog box. If the keyswitch is in the REM position, click OK

to switch the

processor from Program mode to Run mode.

Note: If you receive an error message during these steps, refer to your RSLogix documentation to

interpret and correct the error.

1 2 ... 32 33 34 35 36 37 38 39 40 41 42 ... 78 79

Pas de commentaire

ProSoft Technology inRA-x ILX34-AENWG Guide d'installation Page 37