Prosoft-technology MVI69-ADMNET Manuel d'utilisateur télécharger pdf (Page 54)

Setting Up Your Development Environment MVI-ADMNET ♦ 'C' Programmable

Developer's Guide 'C' Programmable Application Development Module with Ethernet

Page 54 of 122 ProSoft Technology, Inc.

February 20, 2013

Special care must be taken when defining the files for the side-connect interface.

Because the module directly interacts with the PLC processor and its memory,

any errors in the configuration may cause the processor to fault and it may even

lose its configuration program. After defining the files and populating them with

the correct data, download the program to the processor, and place the

processor in Run mode. If everything is configured properly, the module should

start its normal operation.

If all the configuration parameters are set correctly, the module’s application LED

(OK LED) should remain off and the backplane activity LED (BP ACT) should

blink rapidly. Refer to the Diagnostics and Troubleshooting of this manual if you

encounter errors. Attach a terminal to Port 1 on the module and look at the status

of the module using the Configuration/Debug Menu in the module.

1 2 ... 49 50 51 52 53 54 55 56 57 58 59 ... 121 122

Pas de commentaire

Prosoft-technology MVI69-ADMNET Manuel d'utilisateur Page 54