ProSoft Technology ProSoft 1560 Manuel d'utilisateur télécharger pdf (Page 15)

1560-PDP

PROFIBUS – SCANport Adapter

Appendix A : Device Specific Hints

A.1 SMC Dialogue Plus

The SMC Dialogue Plus does not support Datalinks, therefore the configuration of SW2-

7 and 8 should not include any of the Datalinks Enabled. If a Datalink is enabled, the

SCANport Status LED will toggle, indicating an error in the SCANport communications.

The version of SMC which was tested (Rev 1.05) had 88 parameters. The 1560-PDP is

able to read 32 of the parameters out of the SMP3 unit.

A.2 SMP 3

The SMP3 does not support Datalinks, therefore the configuration of Datalinks should

not include any of the Datalinks Enabled. If a Datalink is enabled, the SCANport Status

LED will toggle, indicating an error in the SCANport communications. The 1560-PDP is

able to read 32 of the parameters out of the SMP3 unit.

A.3 Variable Speed Drives

In order to enable Frequency control from the 1560-PDP, the drive parameter

FREQUENCY SELECT 2 must be configured for the appropriate Adapter ID

representing the 1560-PDP module. This will normally be Adaptor #2, unless a

SCANport expander is being used (in which case this Adaptor number will be based on

the port the 1560-PDP is plugged into).

Setting up the Adaptor I/O - Datalinks Out

Selects the parameter values which will be made available from the 1560-PDP

via Global Data Out. Placement of the values in the 1560-PDP is referenced in

Section #

Data Out

Image

Suggested

Parameter

Description

Output Current

Output Volts

Output Power

DC Bus Voltage

Max Frequency

Last Fault

Setting up the Adaptor I/O - Data In

Selects the parameters which will be made accessible for configuration/ writing

from the 1560-PDP. As with the Data Out parameters, there are eight possible

selections. These may be chosen by the programmer to meet the needs of the

application.

1 2 ... 10 11 12 13 14 15 16 17 18 19 20 ... 26 27

Pas de commentaire

ProSoft Technology ProSoft 1560 Manuel d'utilisateur Page 15