ProSoft Technology QTS-CLX-PVX Manuel d'utilisateur télécharger pdf (Page 10)

Page 4 QTS-CLX-PVX September 2009

Installation

Prevent Electrostatic Discharge

The module is sensitive to electrostatic discharge.

WARNING!

ATTENTION: Electrostatic discharge can damage integrated circuits

or semiconductors if you touch backplane connector pins. Follow these

guidelines when you handle the module:

 Touch a grounded object to discharge static potential

 Wear an approved wrist-strap grounding device

 Do not touch the backplane connector or connector pins

 Do not touch circuit components inside the module

 If available, use a static-safe work station

 When the module is not in use, keep it in its static-shield packaging

Prepare the Chassis for Module Installation

Before you install the ControlLogix module, you must install and connect a ControlLogix

chassis and power supply. To install these products, refer to the installation instructions

you received with them.

Determine Module Slot Location

This example shows chassis slot numbering in a 4-slot chassis. Slot 0 is the first slot and

is always located to the right of the power supply. You can use any size ControlLogix

chassis and install the module in any slot.

Figure 1 Chassis Slots

1 2 ... 5 6 7 8 9 10 11 12 13 14 15 ... 45 46

Pas de commentaire

ProSoft Technology QTS-CLX-PVX Manuel d'utilisateur Page 10